Arte SheetsLearn. Try. Understand.

Flight Mechanics, Structural V-n Envelope & Aircraft Design

Wing Loading and an Idealised Lift-Curve Intersection

Use the lift equation for an educational wing-loading example and distinguish its theoretical intersection from an aircraft’s approved maneuvering speed.

A simple lift-equation illustration

For the simplified relation L = ½ρV²SC_L, wing loading is W/S. With a specified maximum lift coefficient C_Lmax and air density ρ, the 1g lift-balance speed in this ideal model is √[2(W/S)/(ρC_Lmax)]. If a hypothetical positive load factor n is imposed while the other quantities remain fixed, the model’s stall-boundary intersection is the 1g value multiplied by √n.

For hypothetical inputs W = 12,250 N, S = 10 m², ρ = 1.225 kg/m³, C_Lmax = 1.25 and n = 4, the model yields W/S = 1,225 N/m², a 1g value of 40 m/s and an n = 4 intersection at 80 m/s. These are true airspeeds in the selected density model, not cockpit indicated speeds or values for an identified aircraft. The corresponding model dynamic pressure is 3,920 Pa.

With all other model inputs held fixed, reducing W to 7,840 N yields a 1g model speed of 32 m/s and an n = 4 intersection of 64 m/s. This demonstrates the square-root relationship for the stated assumptions; it does not determine an operating speed.

Hypothetical weightWing loading W/S1g model speedn = 4 model intersection
12,250 N1,225 N/m²40 m/s80 m/s
7,840 N784 N/m²32 m/s64 m/s

Calculate the model intersection

Enter positive weight, wing area, air density and maximum lift coefficient, and an illustrative load factor of at least one. The worksheet calculates from the unrounded inputs and rounds outputs for display. It does not establish the lift coefficient, density, actual flight envelope or the aircraft’s certified limitations.

=IF(COUNT(B2:B6)<>5,"Enter all numeric inputs",IF(OR(B2<=0,B3<=0,B4<=0,B5<=0,B6<1),"Check example inputs",ROUND(SQRT(2*(B2/B3)*B6/(B4*B5)),2)))

The model intersection is not an approved V_A

Do not equate the theoretical intersection automatically with a particular aircraft’s certified design maneuvering speed V_A. FAA certification guidance explains that V_A is selected subject to design requirements and may differ from the simple V_s√n intersection. The applicable flight manual and aircraft-specific operating limitations are the source for actual speeds and procedures.

FAA guidance also warns that V_A does not permit unrestricted control movement or serve as a general gust-penetration speed. Rapid alternating or combined control inputs can exceed structural limits even below V_A. This worksheet must not be used to select a flight speed or assess structural safety.

Try the example

Use the original values or change them to test your understanding.

Further reading