Process Safety, API 520 Pressure-Relief Sizing & Mechanical Integrity
Pressure-Relief Data: Flow and Pressure Unit Conversions
Convert a hypothetical US liquid flow rate and pressure difference to SI units, and understand the limits of this calculation for relief-system design.
Use consistent units in process data
For a liquid flow rate measured in US gallons per minute, multiply by 3.785411784 to obtain litres per minute. A pressure difference in psi can be converted to kilopascals by multiplying by approximately 6.894757. These are unit conversions only; they do not determine required relieving flow, pressure or valve capacity.
For example, 400 US gal/min is approximately 1,514.16 L/min, and a 100 psi pressure difference is approximately 689.48 kPa. Gauge, absolute and differential pressures are different quantities: converting units does not change one pressure reference into another. An imperial gallon is also different from a US gallon.
| Hypothetical input | Conversion | Result |
|---|---|---|
| 400 US gal/min | × 3.785411784 | 1,514.16 L/min |
| 100 psi pressure difference | × 6.894757 | 689.48 kPa difference |
Spreadsheet conversions
B2 holds the US-gallon-per-minute flow and B3 the pressure difference in psi. Each output validates its own nonnegative numeric input and rounds the converted value to two decimals.
=IF(COUNT(B2)<>1,"Enter a numeric value",IF(B2<0,"Check the input",ROUND(B2*3.785411784,2)))Relief-device selection is a separate engineering task
A relief system requires a documented assessment of applicable overpressure scenarios, relieving flow and conditions, fluid properties, certified device characteristics, inlet and outlet pressure losses and the entire discharge system. Rupture disks or other equipment can change the applicable analysis. A unit conversion is not a valve-sizing method and does not select an orifice, set pressure or installation.
API publishes standards covering pressure-relieving device sizing, selection and installation; OSHA discusses relief-system design and back-pressure hazards. Qualified personnel should use the applicable current standards, project design basis and manufacturer data for the specific system.
Try the example
Use the original values or change them to test your understanding.