Arte SheetsLearn. Try. Understand.

Engineering

Hagen-Poiseuille Laminar Flow formula: R^4 radius law & hydraulic resistance

Calculate ideal fully developed laminar flow, hydraulic resistance and a Reynolds-number applicability check for a straight round tube.

Radius-to-the-fourth scaling within the laminar model

Assume steady, fully developed, incompressible Newtonian flow in a straight rigid circular tube with no slip. Radius is internal radius in metres; dynamic viscosity is in Pa·s, length in metres and signed pressure drop in pascals. The formula is not a clinical model of arteries or an infusion-device specification.

B6 supplies fluid density for a Reynolds-number check using the predicted mean velocity and diameter2R. This exercise rejects predicted Re>=2000 as outside its selected laminar range. Passing that check alone does not establish fully developed flow or all other assumptions.

The revised example uses100Pa and density1000kg/m³: predicted Re400 and flow 1.2566 mL/s. The previous1000Pa input would predict Re4000, inconsistent with the assumed laminar regime. Halving radius at fixed pressure and other parameters divides modeled flow by 16.

Capillary ParameterCellSI InputFlow Output
Internal Radius R (m)B20.002 m (2 mm)R^4 = 1.6E-11 m^4
Pressure Drop dP (Pa)B3100 PaDriving pressure head
Viscosity mu & Length LB4 = 0.001 Pa*s, B5 = 0.5 mAssumed constant viscosity, 0.5 m tube8 * mu * L = 0.004
Flow Rate Q (mL/s)Poiseuille Law0.4 * PI() = 1.2566 mL/sAt radius1mm:0.0785 mL/s

Hagen-Poiseuille laminar flow rate in mL/s (cm^3/s)

Multiply m³/s by 1,000,000 to obtain mL/s. The sign follows the chosen pressure-drop direction.

=IF(OR(COUNT(B2:B6)<>5,B2<=0,B4<=0,B5<=0,B6<=0),"Invalid inputs",IF(B6*ABS(B3)*B2^3/(4*B4^2*B5)>=2000,"Outside laminar model",ROUND(1000000*PI()*B2^4*B3/(8*B4*B5),4)))

Hydraulic resistance in Pa·s/m³

This expression returns resistance, not pressure. Multiply unrounded resistance by a target flow in m³/s to get the required pressure difference, then check applicability again.

=IF(OR(COUNT(B2:B6)<>5,B2<=0,B4<=0,B5<=0,B6<=0),"Invalid inputs",ROUND((8 * B4 * B5) / (PI() * (B2 ^ 4)), 0))

Check predicted Reynolds number

Use the magnitude of velocity for Reynolds number; flow direction does not change the regime check.

=IF(OR(COUNT(B2:B6)<>5,B2<=0,B4<=0,B5<=0,B6<=0),"Invalid inputs",ROUND(B6*ABS(B3)*B2^3/(4*B4^2*B5),2))

Try the example

Use the original values or change them to test your understanding.

Further reading