Arte SheetsLearn. Try. Understand.

Electrical Power Safety & Switchgear Protection, IEEE 1584 & NFPA 70E Arc Flash

Incident Energy Units and Arc-Flash Assessment

Convert energy per area between joules and thermochemical calories, and understand why conversion alone cannot establish an arc-flash boundary or PPE category.

Convert the units, not the hazard

Incident energy may be reported in joules per square centimetre (J/cm²) or calories per square centimetre (cal/cm²). Using the thermochemical calorie, 1 cal = 4.184 J. Divide J/cm² by 4.184 to express the same energy per unit area in cal/cm²; multiply cal/cm² by 4.184 for the reverse conversion.

For example, 9.69 J/cm² is approximately 2.3160 cal/cm², and 4.00 cal/cm² is 16.736 J/cm². These are hypothetical values for unit practice, not measured or estimated incident energy for a particular job.

Given quantityConversionEquivalent quantity
9.69 J/cm²9.69 / 4.1842.3160 cal/cm²
4.00 cal/cm²4.00 × 4.18416.7360 J/cm²

Spreadsheet conversion

Enter a nonnegative numeric value in B2 for J/cm² to cal/cm², or in B3 for cal/cm² to J/cm². The cells only convert units; they do not calculate incident energy.

=IF(COUNT(B2)<>1,"Enter a numeric value",IF(B2<0,"Check the input",ROUND(B2/4.184,4)))

Arc-flash assessment and PPE selection

A real arc-flash risk assessment depends on the electrical system and the task, including fault characteristics, protective-device behavior, equipment configuration and working distance. A unit conversion cannot determine incident energy, a boundary, the correct equipment or safe working conditions.

NFPA explains that the incident-energy analysis and arc-flash PPE category methods are distinct; assigning an arc-flash PPE category directly from a calculated incident-energy number is not the category method. Qualified personnel should use the applicable current requirements, site assessment and equipment procedures. Follow applicable safe-work practices and do not use this worksheet to select PPE or authorize energized work.

Try the example

Use the original values or change them to test your understanding.

Further reading