Arte SheetsLearn. Try. Understand.

Clinical Medicine & Physiology

Jackson–Pollock Three-Site Skinfold Equations: Density and Body-Fat Estimates

Compare the Jackson–Pollock and Jackson–Pollock–Ward three-site body-density equations and a separate Siri conversion, with input checks and source-population limitations.

Two three-site equations

Jackson and Pollock developed body-density prediction equations from a sample of 308 men aged 18–61, with a separate sample used for cross-validation. Jackson, Pollock and Ward later studied 249 women aged 18–55 and cross-validated in a further sample. The original women’s study advised caution for women over 40.

These equations predict density from three skinfolds and age. The male equation uses chest, abdomen and thigh; the female equation uses triceps, suprailiac and thigh. The Siri conversion is a second model that estimates body-fat percentage from density. Measurement technique, model assumptions and differences between individuals can affect results; neither output is a direct measure of body fat.

Study group and ageThree sites in mmEstimated density (g/cm³)Siri estimate (%)
Male, 30Chest 10; abdomen 18; thigh 141.0697612.72
Female, 30Triceps 16; suprailiac 15; thigh 231.0484122.15

Enter the density calculation

Enter M or F for the original study group in B2, age in completed years in B3, and the three corresponding positive skinfold measurements in B4:B6. Enter this formula in B7; it retains unrounded density for the next step.

The example limits age to the ranges of the two original samples and the sum of folds to 220 mm as an exercise guard. These checks do not establish that any input or prediction is valid for an individual.

=IF(COUNT(B3:B6)<>4,"Enter numeric age and all three skinfolds",IF(OR(AND(B2<>"M",B2<>"F"),B3<>INT(B3),B3<18,AND(B2="M",B3>61),AND(B2="F",B3>55),MIN(B4:B6)<=0,SUM(B4:B6)>220),"Check example inputs",IF(B2="M",1.10938-0.0008267*SUM(B4:B6)+0.0000016*SUM(B4:B6)^2-0.0002574*B3,1.0994921-0.0009929*SUM(B4:B6)+0.0000023*SUM(B4:B6)^2-0.0001392*B3)))

Display estimated density

Use the unrounded B7 value to display density. Extra decimals reproduce the calculation, not measurement accuracy.

=IF(ISNUMBER(B7),ROUND(B7,5),B7)

Convert with the Siri model

This separate formula uses unrounded B7, checks for a positive density and rejects outputs outside 0–100%. A result within those mathematical bounds does not validate the prediction.

=IF(ISNUMBER(B7),IF(B7<=0,"Check calculated density",IF(OR(495/B7-450<0,495/B7-450>100),"Outside model bounds",ROUND(495/B7-450,2))),B7)

Try the example

Use the original values or change them to test your understanding.

Further reading