Arte SheetsLearn. Try. Understand.

Preventive Cardiology, Clinical Lipidology & Laboratory Diagnostics

Adjustable-Factor LDL-C: Martin–Hopkins and Sampson Context

See why the Martin–Hopkins divisor needs the published lookup table and compare estimates using a clearly fictional divisor.

How the methods differ

Friedewald estimates LDL-C as total cholesterol minus HDL-C minus triglycerides divided by 5 (all in mg/dL). The 2013 Martin–Hopkins method replaces the fixed divisor with a value selected from a table according to triglyceride and non-HDL cholesterol strata. A freely chosen divisor is not necessarily the correct Martin–Hopkins factor.

The Sampson–NIH equation is a different method with its own coefficients and validation. All of these are estimates, not direct measurements of an individual’s true LDL-C. Differences between estimates do not by themselves establish the true error or dictate treatment.

A generic adjustable-divisor arithmetic example

Enter total cholesterol, HDL-C and triglycerides in B2:B4 (mg/dL), and an explicitly hypothetical positive divisor in B5. The exercise uses a divisor of 6.8 solely to show how the arithmetic changes. It does not look up or verify the correct Martin–Hopkins stratum and therefore does not implement that clinical method.

The comparison is limited to triglycerides below 400 mg/dL because the original Friedewald equation is not validated at 400 or above. A later extended Martin–Hopkins method covers other triglyceride ranges but is not implemented here. Negative estimates are rejected.

=IF(COUNT(B2:B5)<>4,"Enter valid numeric values in mg/dL and a positive divisor",IF(OR(B3<=0,B2<=B3,B4<=0,B5<=0),"Enter valid numeric values in mg/dL and a positive divisor",IF(B4>=400,"Friedewald comparison is not offered at TG 400 mg/dL or above",IF((B2-B3-B4/B5)<0,"Negative estimate: check inputs and consult the laboratory",ROUND((B2-B3-B4/B5),2)))))

Compare the fictional estimates

For total cholesterol 165, HDL-C 40 and triglycerides 272 mg/dL, the fictional divisor 6.8 produces 85.0 mg/dL; division by 5 produces 70.6 mg/dL. The signed difference is +14.4 mg/dL. This does not prove that either is the correct result for these values.

=IF(COUNT(B2:B5)<>4,"Enter valid numeric values in mg/dL and a positive divisor",IF(OR(B3<=0,B2<=B3,B4<=0,B5<=0),"Enter valid numeric values in mg/dL and a positive divisor",IF(B4>=400,"Friedewald comparison is not offered at TG 400 mg/dL or above",IF(OR((B2-B3-B4/B5)<0,(B2-B3-B4/5)<0),"Negative estimate: check inputs and consult the laboratory",ROUND((B2-B3-B4/B5)-(B2-B3-B4/5),2)))))

Further reading

The original study describes the 180-cell lookup table and its validation. The separate Sampson–NIH article explains that equation. For clinical results use the reporting laboratory’s approved method and consult a qualified clinician.

Try the example

Use the original values or change them to test your understanding.

Further reading