Fire Protection Engineering, NFPA 13 Hydraulic Calculations & Sprinkler Design
Sprinkler K-Factor: Illustrative Flow and Pressure Arithmetic
Explore the relationship Q = K√P for a single hypothetical sprinkler and the separate steps needed for a real fire-protection design.
The K-factor equation
For a sprinkler with a stated K-factor in gpm/√psi and residual pressure P in psi, the idealized discharge relation is Q = K × √P in gallons per minute. If an illustrative target flow Q is known, the same equation rearranges to P = (Q/K)². These calculations concern a single outlet and depend on consistent units and the correct K-factor for the listed sprinkler.
The required pressure for an actual sprinkler system also depends on the adopted code and edition, the sprinkler’s listing and manufacturer instructions, hazard and arrangement, hydraulics, water supply and the authority having jurisdiction. A 7 psi baseline in some code provisions does not replace a higher listed minimum or validate an entire system.
| Hypothetical K and inputs | Arithmetic | Result |
|---|---|---|
| K = 5.6 gpm/√psi; P = 16 psi | 5.6 × √16 | 22.40 gpm |
| K = 5.6 gpm/√psi; target Q = 19.5 gpm | (19.5 / 5.6)² | 12.13 psi |
| K = 8.0 gpm/√psi; target Q = 26 gpm | (26 / 8.0)² | 10.56 psi |
Calculate a single-outlet flow
Enter a positive K-factor in B2 and nonnegative residual pressure in B3. The result is mathematical flow for the stated inputs, not proof of required discharge or code compliance.
=IF(COUNT(B2:B3)<>2,"Enter numeric K and pressure",IF(OR(B2<=0,B3<0),"Check K and pressure",ROUND(B2*SQRT(B3),2)))Calculate pressure from a hypothetical target flow
Enter the target flow in B4. The result is the pressure implied by the idealized single-outlet equation only; it does not apply minimum listing requirements, pipe losses or other system constraints. Actual fire-protection design and acceptance require the applicable standards and qualified professionals.
=IF(COUNT(B2,B4)<>2,"Enter numeric K and target flow",IF(OR(B2<=0,B4<0),"Check K and target flow",ROUND((B4/B2)^2,2)))Try the example
Use the original values or change them to test your understanding.