Arte SheetsLearn. Try. Understand.

Healthcare & Clinical Formulas

Scatchard Plot: A Synthetic Binding-Equation Example

Learn the slope and intercept relationship of a single-site Scatchard transformation with synthetic data, and understand why actual binding data are normally fit by nonlinear regression.

The one-site equation

For a reversible single-site equilibrium model, specific binding B = Bmax × F / (Kd + F), where F is the free ligand concentration. Algebra gives B/F = −B/Kd + Bmax/Kd. A plot of B/F versus B is a straight line for ideal model-generated data: its slope is −1/Kd and its x-intercept is Bmax. Kd uses the units of F; Bmax uses the units in which specific binding B was measured.

The four data points below are deliberately noiseless and illustrate algebra only. For real experiments, the transformation shares B between both axes and changes the error distribution; ordinary regression on a Scatchard plot can yield biased estimates. Fit an appropriate binding model to the untransformed experimental data by nonlinear regression and account for nonspecific binding and ligand depletion where needed. A nonnegative fitted slope alone does not establish cooperativity.

Free F (nM)Specific bound B (fmol/mg)B/F
1.252419.2
5.006012.0
15.00906.0
45.001082.4

Calculate a teaching-only Kd from the line

Enter positive free concentrations in A2:A5, nonnegative specific binding values in B2:B5, and the B/F ratios in C2:C5. The example returns 5.00 nM. Input and slope checks only prevent basic invalid arithmetic; they cannot verify equilibrium, the binding model or experimental quality.

=IF(COUNT(A2:B5)<>8,"Enter numeric F and B",IF(OR(MIN(A2:A5)<=0,MIN(B2:B5)<0,MAX(B2:B5)=MIN(B2:B5)),"Check F and B",IF(COUNT(C2:C5)<>4,"Check B/F ratios",IF(SLOPE(C2:C5,B2:B5)>=0,"Slope must be negative",IF(INTERCEPT(C2:C5,B2:B5)<=0,"Check intercept",ROUND(-1/SLOPE(C2:C5,B2:B5),2))))))

Calculate a teaching-only Bmax from the intercept

The synthetic line has a Bmax of 120.0 fmol/mg. If a different assay uses a different binding or surface-response unit, Bmax retains that unit; do not interpret a sensor response as receptor density without an appropriate calibration.

=IF(COUNT(A2:B5)<>8,"Enter numeric F and B",IF(OR(MIN(A2:A5)<=0,MIN(B2:B5)<0,MAX(B2:B5)=MIN(B2:B5)),"Check F and B",IF(COUNT(C2:C5)<>4,"Check B/F ratios",IF(SLOPE(C2:C5,B2:B5)>=0,"Slope must be negative",IF(INTERCEPT(C2:C5,B2:B5)<=0,"Check intercept",ROUND(-INTERCEPT(C2:C5,B2:B5)/SLOPE(C2:C5,B2:B5),1))))))

Try the example

Use the original values or change them to test your understanding.

Further reading