Arte SheetsLearn. Try. Understand.

Clinical Medicine & Physiology

Siri and Brožek Body Density Equations: Comparing Body-Fat Estimates

Compare Siri and Brožek estimates of body-fat percentage from body density, and calculate an illustrative fat-free mass while keeping model assumptions and measurement limitations clear.

Two estimates from body density

Body density is body mass divided by body volume. Underwater weighing and air-displacement plethysmography estimate volume using different methods and corrections; skinfold equations can instead produce an estimated density. In either case, converting density to fat percentage adds model assumptions and does not directly measure fat mass.

The commonly used Siri equation, 495/density − 450, follows a simplified two-component model using fat density of approximately 0.900 g/cm³ and fat-free mass density of 1.100 g/cm³. Brožek and colleagues’ 1963 equation, 457/density − 414.2, uses a different reference-body model. Neither is universally preferred across all populations; individual variation in fat-free mass composition and measurement conditions can affect both.

Density (g/cm³)Siri estimate (%)Brožek estimate (%)Siri-derived fat-free mass at 80 kg
1.07510.4710.9271.63 kg
1.05519.1918.9864.64 kg
1.03030.5829.4955.53 kg

Siri percentage estimate

Put density in g/cm³ in B2. The arithmetic example requires a positive number and rejects values for which this model produces less than 0% or more than 100% fat. This mathematical guard is not a validated physiological range, and a result within it does not establish the model’s suitability.

=IF(COUNT(B2)<>1,"Enter numeric density",IF(B2<=0,"Check density",IF(OR(495/B2-450<0,495/B2-450>100),"Outside model bounds",ROUND(495/B2-450,2))))

Brožek percentage estimate

Apply the separate Brožek calculation to the same density. A small difference between the outputs reflects different model assumptions, not proof that one is correct for a particular person.

=IF(COUNT(B2)<>1,"Enter numeric density",IF(B2<=0,"Check density",IF(OR(457/B2-414.2<0,457/B2-414.2>100),"Outside model bounds",ROUND(457/B2-414.2,2))))

Illustrative fat-free mass

With density in B2 and a positive body mass in kilograms in B3, use the unrounded Siri percentage to calculate fat-free mass. This is an estimate and inherits the same limitations as the density and conversion model.

=IF(COUNT(B2:B3)<>2,"Enter numeric density and mass",IF(OR(B2<=0,B3<=0),"Check density and mass",IF(OR(495/B2-450<0,495/B2-450>100),"Outside model bounds",ROUND(B3*(1-(495/B2-450)/100),2))))

Try the example

Use the original values or change them to test your understanding.

Further reading