Arte SheetsLearn. Try. Understand.

Civil Engineering, Tunneling & Materials

Shotcrete: Geometric Volume and Rebound Mass Example

Practice the separate calculations for nominal lining volume and measured rebound by mass, and understand why neither determines tunnel-support safety.

Keep volume and mass calculations separate

For a simplified surface with uniform thickness, the nominal in-place geometric volume is area × thickness. A hypothetical 65 m² surface at 100 mm thickness has a nominal volume of 6.50 m³. Actual quantities depend on geometry, surface irregularity, placement, quality requirements and project measurements.

US Army Corps of Engineers guidance defines shotcrete rebound percentage by dividing the mass of material that rebounds by the mass delivered through the nozzle. For an illustrative 1,000 kg delivered and 180 kg rebound, the rebound fraction is 18%. If the exercise assumes rebound is the only loss, the remaining mass is 820 kg; that assumption is not a measurement of in-place concrete volume.

Rebound often has a different composition from the delivered material. Its mass fraction cannot automatically be treated as a delivered-volume loss percentage. Estimating actual in-place yield and ordering quantities requires appropriate field measurements, mixture data, other losses and the project specifications.

Illustrative quantityCalculationResult
Nominal in-place geometric volume65 m² × 100 mm / 10006.50 m³
Rebound by mass180 kg / 1000 kg × 10018%
Remaining mass if rebound is the only loss1000 kg − 180 kg820 kg

Calculate rebound percentage

Enter a positive surface area, thickness and nozzle-delivered mass, and a rebound mass from zero to the delivered mass. The worksheet computes nominal geometric volume, rebound percentage and the remainder under the one-loss assumption. Mass values must use the same measurement basis and include the material delivered at the nozzle.

=IF(COUNT(B2:B5)<>4,"Enter all numeric inputs",IF(OR(B2<=0,B3<=0,B4<=0,B5<0,B5>B4),"Check example inputs",ROUND(100*B5/B4,2)))

Tunnel support needs a separate engineering design

These arithmetic results do not determine whether shotcrete, anchors or a tunnel roof are safe. Ground conditions, discontinuities, excavation sequence, bond, installed support, testing and the project ground-control plan all matter. Bolt steel yield strength alone does not determine the capacity or performance of a complete rock-support system.

Follow the approved ground-support design, competent-person inspections and applicable requirements. The linked FHWA, NIOSH and OSHA references discuss underground support, shotcrete testing and ground-condition inspections.

Try the example

Use the original values or change them to test your understanding.

Further reading